Transform your base model into a traffic-taming commuter. This step-by-step City Kit guide covers tools, safety, installation, and checks so you can ride away confident—and quiet.
Estimated time: 45–75 minutes (first-time installer).
Skill level: Beginner to intermediate.
Safety first: Power off the bike and remove the battery before any work.
What’s in the box (typical contents)
-
Front and rear lights or light mounts
-
Fenders and hardware set
-
Rear rack with mounting plates
-
Control switches/brackets and cable ties
-
Fasteners labeled by step
Tools you’ll need
Hex key set, torque wrench, side-cutters for zip-ties, electrical tape, clean cloth, mild cleaner. Always follow model-specific torque values.
Step-by-step installation
1) Unbox & verify
-
Lay out all components and fasteners.
-
Cross-check with the packing list.
-
Inspect for shipping damage.
2) Prep the bike
-
Power off, remove the battery.
-
Mount the bike securely on a stand.
-
Clean contact areas to ensure accurate torque.
3) Controls & cockpit
-
Dry-fit any switch pods and brackets to visualize cable runs.
-
Mount controls within easy reach without pinching cables when the bars turn fully.
-
Lightly snug bolts; final torque comes later.
4) Front & rear lighting
-
Install light mounts to designated bosses.
-
Route cables along factory harness paths; leave a gentle service loop for steering.
-
Secure with zip-ties at intervals; avoid sharp bends and moving parts.
5) Fenders
-
Start with the front fender: align stays, then set clearance around the tire.
-
Install the rear fender, checking for chain/tire clearance at full suspension travel (if applicable).
-
Tighten hardware gradually in a cross pattern to avoid rubbing.
6) Rear rack
-
Attach mounting plates at the dropout and seat-stay points.
-
Level the rack; verify pannier clearance.
-
Torque to spec, using thread treatment where recommended.
7) Cable management & finishing
-
Confirm nothing contacts the tire, disc, or chainring.
-
Trim zip-ties flush.
-
Re-install the battery and power up.
Post-install checks (10 minutes)
-
Lighting: On/off and brake-triggered functions.
-
Braking: No cable rub; levers return crisply.
-
Steering: Turn bars lock-to-lock—no tugging on cables.
-
Road test: Low-speed ride; listen for rattles. Re-torque after 10–20 km.
Troubleshooting
-
Rattle near the rear wheel: Check rack/fender shared mounts for proper spacing.
-
Cable too long: Use an S-shaped loop and additional ties; never wrap tightly around the steerer.
-
Light flicker: Reseat connectors; inspect for pinched wiring.
When to ask for help
If you lack the tools or encounter stripped hardware, book an appointment with our authorized service partner network.
CTA
-
Watch the full installation video and add the City Kit to your cart.
-
Not sure about fit? Take the Product Finder Quiz and confirm on the Compatible Kits page before ordering.